Does the MDS9222i GigE ports support 100BaseT IP network?
Do the four GigE ports on the MDS 9222i and 18/4 module support a 100BaseT IP network? In other works can I connect the GigE port to a 100BaseT connection or does it have to be physically connected to a 1000Mb/s connection? I have an IP cloud that has an actual max WAN speed of 35Mb/s. Can I set the "max-bandwidth-mbps" down to 35Mb/s?
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...