I'm trying to configure a NM-CE-BP-80G-K9 and when I try to assign an external ip to it, it gives me the error below. I have previously done a password recovery, then a write erase to clear the config, then a reload on the module. The module accepted the command before the write erase, but not after. I'm hoping it's something small i'm missing. Thanks for any help you can give.
Router(config-if)#service-module external ip address 10.0.0.2
*Mar 1 01:50:47.084: %SERVICEMODULE-2-IPCONFIGFAILED: Service module
Content-Engine1/0 IP configuration (external) failed
Topology & Design:
Two ACI fabrics
Stretching VLANs using OTV
Both fabrics are advertising BD subnets into same routing domain
Some BDs(or say VLANs) are stretched, but some are not.
Endpoints can move betwee...
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
Topology &Design:Traffic flow within same fabric:Endpoint moves to Fabric-2Bounce Entry Times OutTraffic Black-holedSummarySolutionAppendix:
In the Previous articles of ACI Automation, we are using Postman/Newman a...