Lets put it this way, in a large fabric, it makes a lot of sense to use it especially to check what is being added. This is the age of the GUI which is really surprising that it comes from a UNIX boffin who just loves the command line.
I find it much easier to use for port channels than the cli and fc aliases are a right pig to enter into the cli. Sooner or later, you are bound to make a mistake with a WWN. Its bad enough for lun masking on array where more often than not you have to type in the WWN.
Are we just doing this to add some entries into the forum??
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...