I have a 9216i’s (nxos 4.2) and a 6120 (ucs 2.0) that I am trying to configure a san-port-channel to port-channel with and I can’t get it working. The FC (F-NP) links work when they are not in a po, but when I try to form a port-channel I get “invalidCfg” on the MDS switch.
I am setting it up with only one link to start with.
What is wrong with this config or is their a bug?
The MDS switch has NPIV enabled.
UCS
interface san-port-channel 100
channel mode active
switchport mode NP
switchport trunk mode on
interface fc2/1
switchport mode NP
switchport trunk mode on
channel-group 100 force
no shutdown
MDS
interface port-channel 100
channel mode active
switchport mode F
switchport speed 2000
switchport rate-mode dedicated
no shutdown
interface fc1/1
switchport speed 2000
switchport mode F
channel-group 100 force
no shutdown
MDS-1(config-if)# 2013 Oct 21 10:14:57 MDS-1 %PORT-5-IF_DOWN_INVALID_CONFIG: %$VSAN 1%$
Interface fc1/1 is down(Error disabled - Possible PortChannel misconfiguration)
MDS
-------------------------------------------------------------------------------
Interface Vsan Admin Admin Status SFP Oper Oper Port
Mode Trunk Mode Speed Channel
Mode (Gbps)
-------------------------------------------------------------------------------
fc1/1 1 F on invalidCfg swl -- 100
UCS
-------------------------------------------------------------------------------
Interface Vsan Admin Admin Status SFP Oper Oper Port
Mode Trunk Mode Speed Channel
Mode (Gbps)
-------------------------------------------------------------------------------
fc2/1 1 NP on notConnected swl -- 100
