Hi Vu,
That means there will be QOS config if we configured FCOE during the initial setup. Can we assume that the below qos setting is the default config requirement?
As all our customer's N4k are in production and we need to make sure not to be any impact. Also not possible to get a spare to test, that's why, we need Cisco confirmation or official document.
policy-map type queuing policy-fcoe-bandwidth
class type queuing 1p7q4t-out-q-default
bandwidth percent 50
class type queuing 1p7q4t-out-pq1
bandwidth percent 7
class type queuing 1p7q4t-out-q2
bandwidth percent 7
class type queuing 1p7q4t-out-q3
bandwidth percent 7
class type queuing 1p7q4t-out-q4
bandwidth percent 7
class type queuing 1p7q4t-out-q5
bandwidth percent 7
class type queuing 1p7q4t-out-q6
bandwidth percent 7
class type queuing 1p7q4t-out-q7
bandwidth percent 7
class-map type network-qos Jumbo1
match cos 4
class-map type network-qos class-fcoe
match cos 3
class-map type network-qos class-non-fcoe
match cos 0-2,4-7
policy-map type network-qos Jumbo
class type network-qos Jumbo1
mtu 9216
policy-map type network-qos policy-fcoe
class type network-qos class-fcoe
pause no-drop
mtu 2500
class type network-qos class-non-fcoe
system qos
service-policy type network-qos policy-fcoe
service-policy type queuing output policy-fcoe-bandwidth policy-map type queuing policy-fcoe-bandwidth
Thanks you so much!
Ye
