In Cisco MDS FMS running on Windows 2003 Server, I see errors like "UknownUSer Name(Server), "Invalid Auth Password or Wrong Digest (Server)" under Status column against each switches and they are yellowed out and errors are occuring randomly. Switches are configured for TACACS authentication and they working fine.
But when I launch the FM installed on my laptop and login, I do not see those errors.
Could someone explain what causes those errors to come.
But AAA (tacacs+) uses Windows AD here. So, whenever a CLI user is created , automatically MDS creates an SNMP user (which I think is temporary) or vice versa. When it is automatically created, why do i need to create one more...would it not amount to duplication
Or are they temporary ?
Do you mean to say "create permanent users' using snmp-server command.
If that is going to be the case,then how the passwords will be synchronised between CLI users (AD users via TACACS+) and SNMP users...i know some automatic synchronization happen implicitly.
Also, I read the following Note from Cisco MDS config guide 3.0
For an SNMPv3 operation using the external AAA server, user configurations in the external AAA server require AES to be the
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...