I am trying to connect a Qlogic switch to an upstream 9506. QLogic states that it supports a feature called transparent routing. I have done all the appropriate configuration, but the Qlogic does not see any remote devices from the Cisco switch. I have NPIV enabled on the 9500 and it sees the Qlogic as a host. Is there anything I need to do on the 9500 to push down it's members to the Qlogic switch?
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...