Is it possible the zoning is not correct on the 5428? Are you using LUN security of some sort? If you issue a show fcswitch command, the last two lines will be the pwwn's of the 5428 that the iscsi initiators will use to access the storage. Make sure these two pwwn's are zoned and also permitted in the array. Then do a show scsirouter and verify the IP address of the windows device is in the access-list to access the storage.
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...