I want to do read-only zoning with an IVR zone. There's no simple read-only checkbox for IVR zones in Fabric Manager. The only good reference I can find to this is in the 1.3 Fabric Manager Configuration Guide:
"LUN-zoning and read-only zoning can be used between members of active IVR zones. To configure this service, you need to create and activate LUN-zones and/or read-only zones between the desired IVZ members in all relevant edge VSANs using the zoning interface. The LUN zoning and read-only zoning features cannot be configured in a IVZS setup."
This is a little ambiguous. Am I to believe that I need to go in and manually create "ivrz" zones and make them read-only? I'm hesitant to do this since IVR documentation commonly states "Do not create a zone with prefix `IVRZ' or a zone set with name `nozonset'."
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...