Yes. There is something called a MIA, Media Interface adapter, and it will convert copper to Fibre. Usually you plug the MIA into the back on the JBOD and attach the fibre to the MIA and the switch. Often times MIA require SC type fibre connections where as the MDS used LC type connects, just make sure you get a fibre cable that is SC on one end and LC on the other. These cables are common since most patch panels use the SC interface.
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...