LUNs not showing up in Cisco Fabric Manager SCSI Discovery
We have a fully-meshed FC SAN topology with two NetApp 3040 clusters and two Cisco MDS 9140s. Each host holds two Qlogic HBAs that are connected to each switch. No ISL. Now, all the igroups have been created and the LUNs are all mapped accordingly. All of the zones are up and running on each MDS switch. The hosts can see the LUNs. We want the ability to specify the LUN IDs through the switch. Cisco's Fabric Manager, for some reason, does not discover those SCSI targets. It discovers the adapters on the filers, but does not list the LUN IDs. I am posing the same question to our NetApp support group, but I wanted to make sure there I have not missed something on the Cisco side.
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...