We have enabled 2 additional FC ports (19/20) on our Cisco MDS 9120. The VSAN aliases, and Zone Sets are created and pre-existing. All WWN's are advertising correctly, on the SAN, FC physical ports are green..
Now at this point we attempt to view the logical drives on a pair of Win 2K3 servers..in which does not see..We have pre-defined the Zones Sets with an A&B side respectively, and is currently operational with another SAN device..Clarion_EMC..The new SAN FC ports are working properly..so we are at a standstill. The SAN array on the other side is a Hitachi 9570
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...