Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

mds 9124 and fabric manager problem

I have 2 mds 9124 that are working fine with the device manager, but for some reason, i guess security i cant connect with fabric manager, what lines do i need to add the configuration in order to use the fabric manager?

Thanks for all answers

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: mds 9124 and fabric manager problem

If you go to the switches IP Address via a Web Browser it will show you want version you are running.

The Default username and password is "admin" and "password" and server address should be "local". After that you should get the Normal switch login credentials, the same as DM.

6 REPLIES
New Member

Re: mds 9124 and fabric manager problem

Do you get the First Login screen? If so that is a default username and password. You then get the normal login screen after that.

Also I had a problem connecting to DM & FM and that turned out to be "IP ACL", somebody had setup ACL and that was stopping us getting access from certain workstations.

Hope that helps.

New Member

Re: mds 9124 and fabric manager problem

Yep, i get the first login screen, but i get a connection error message when i enter the username & password. And its not an ACL. Maybe i have problem with the FM server.

New Member

Re: mds 9124 and fabric manager problem

What is the error message? Is this from the FM server or workstation?

What version of Firmware are you running?

New Member

Re: mds 9124 and fabric manager problem

What version of Fabric Manager are you running now? The Fabric Manager has two logins, the first being into FMS and the second into the seed switch. Have you tried the default login of admin and password at the first screen?

New Member

Re: mds 9124 and fabric manager problem

I dont know the version, cause i am not in front of the system at the moment. But the problem is with the first login to the FMS, what is the default login? and is to "localhost"?

thanks

New Member

Re: mds 9124 and fabric manager problem

If you go to the switches IP Address via a Web Browser it will show you want version you are running.

The Default username and password is "admin" and "password" and server address should be "local". After that you should get the Normal switch login credentials, the same as DM.

900
Views
0
Helpful
6
Replies