Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MDS 9216i vers. 3.0(2a)

i am having issues with SNMP traps for link up and link down. i run a capture and i see snmp but not snmp traps. any advice?

1 REPLY

Re: MDS 9216i vers. 3.0(2a)

Hi,

Did you enabled the traps?

Use the command snmp-server enable traps

For more infomation before you apply the command:

Look at http://cisco.com/en/US/docs/storage/san_switches/mds9000/sw/rel_3_x/command/reference/CR03_s.html#wp1283710

I hope this helps.

Best regards.

Massimiliano.

125
Views
0
Helpful
1
Replies