I have a problem of using MDS 9506 to connect two NetApp filers (within the same fabric)in order for replication to be done with Snapmirror.Having assined IP address to the FCNIC card on the filers,I couldn't ping accross.I also have a multiprotocol servies module installed on one of the switches.How do I go about this?
So, if you issue a show flogi database, do you see the devices logged in? Next issue show zoneset active and see if they are zoned together. You are trying to do IP over fibre channel, right? Or are you trying to do IP over ethernet?
No, nothing on the IPS blade since this is IP over FC. The mgmt port is for managing the switch with telnet, SSH, or the fabric manager. Fibre channel, as a transport protocol, can carry many upper-layer protocols within it like IP or scsi or ficon. IP like fibre channel can carry upper layer protocols such as fibre channel or web or ftp,etc. So, the gig ports on the MDS are for putting the SAN/IP over IP infrastrucutre or ISCSI. You indicated you wanted to put IP over the SAN/FC which, to the switch, is just plain fibre channel switching.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...