Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MDS FC Port mode for UCS connectivity

Hi,

A little question on admin mode of the MDS switch port which is connected to a UCS Fabric Interconnect.

The switch is a MDS 9509 running SAN OS v3.3, we have enabled NPIV on the MDS switch. Currently the port's admin mode is 'auto' and its operational mode is 'F'.

Therefore is it safe to change the admin mode to 'F' or is it better to keep 'auto' as it is.

Cheers,

Kisanka

Everyone's tags (5)
1 ACCEPTED SOLUTION

Accepted Solutions

MDS FC Port mode for UCS connectivity

You can leave it set to auto, F mode is the correct operational mode for UCS FIs.

3 REPLIES

MDS FC Port mode for UCS connectivity

You can leave it set to auto, F mode is the correct operational mode for UCS FIs.

New Member

MDS FC Port mode for UCS connectivity

Thanks Jeramy. Since the final operational mode is F, is it safe to administratively set the mode to 'F'

MDS FC Port mode for UCS connectivity

Yes, that is fine

724
Views
0
Helpful
3
Replies
CreatePlease login to create content