Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

N7K

Got 3 Qs:

1) how do you save the config on N7K, or on NX in general?

2) How to do image upgrade?

3) Do I need to congif STP? and if so, do I need to config a switch as root? & how I can do that?

Thx.

6 REPLIES
New Member

Re: N7K

What am asking is: do you just:  wr mem like IOS to save the config,.... or it's like the CatOS..just enter2wice.

Thx.

New Member

Re: N7K

Hey Mohamed,

If you want to use the shorthand for write mem aka wr you can use the following command in configuration mode:

cli alias name wr copy run start

This will allow you to copy the running config to the startup config with the familiar wr syntax.

Cisco Employee

Re: N7K

wri mem is not a valid CLI in the NXOS, you have to use copy run start.

For software upgrade procedure, please check out the upgrade guide.

http://www.cisco.com/en/US/docs/switches/datacenter/sw/4_2/nx-os/upgrade/guide/Cisco_Nexus_7000_Series_NX-OS_Software_Upgrade_and_Downgrade_Guide__Release_4.2_chapter1.html

By default, STP is disabled in NXOS. If you have the proper license, you can enable STP, and configure it to fit your environment.

Regards,

jerry

New Member

Re: N7K

Thx. jerry,

New Member

Re: N7K

Jerry,

Can you pls. avise on config redundancy for sup 1 on n7k?

Thx.

Cisco Employee

Re: N7K

Can you post the output of the following commands after inserting the module standby SUP

show system redundancy status

show module

show boot auto-copy

Regards,

jerry

1274
Views
0
Helpful
6
Replies
CreatePlease to create content