05-07-2009 02:00 AM
We already have four IVR Zones in our Zoneset and I need to add two new Zones. Should I edit the Zone database and add the two new Zones or run the Wizard and follow the idoit proof steps? I'm happy to add/remove devices in the non-IVR setup but just wanted to know of any gotcha's in IVR world?
Thanks.
Solved! Go to Solution.
05-07-2009 02:23 AM
Either way, just make sure you are making the changes to the VSAN zoneset or the IVR zoneset on a switch that has IVR enabled.
MDS1---MDS2---MDS3
VSAN1 IVR VSAN2
IVR is only enabled on MDS2 to IVR VSAN1 and VSAN2.
Make changes to VSAN1 local zoneset on MDS2.
Make changes to VSAN2 local zoneset on MDS2
Make changes to IVR zoneset on MDS2
The gotcha is that any zone change must be made on the IVR enabled switch, even if the change is only to the local zoneset.
Hope this helps,
Mike
05-07-2009 02:23 AM
Either way, just make sure you are making the changes to the VSAN zoneset or the IVR zoneset on a switch that has IVR enabled.
MDS1---MDS2---MDS3
VSAN1 IVR VSAN2
IVR is only enabled on MDS2 to IVR VSAN1 and VSAN2.
Make changes to VSAN1 local zoneset on MDS2.
Make changes to VSAN2 local zoneset on MDS2
Make changes to IVR zoneset on MDS2
The gotcha is that any zone change must be made on the IVR enabled switch, even if the change is only to the local zoneset.
Hope this helps,
Mike
05-07-2009 03:30 AM
Thanks.
We have two switches in each fabric and all four switches are IVR enabled. Is that bad design?
05-07-2009 05:41 AM
Nope...that is not a bad design.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: