All switches in the Cisco Nexus 5000 Series distribute active zone sets when new E port links come up or when a new zone set is activated in a VSAN. The zone set distribution takes effect while sending merge requests to the adjacent switch or while activating a zone set.
To enable full zone set and active zone set distribution to all switches on a per VSAN basis, perform this task:
switch# configuration terminal
Enters configuration mode.
switch(config)# zoneset distribute full vsan vsan-id
Enables sending a full zone set along with an active zone set.
however when I entered this command nothing happened.
I was expecting the zone status to show the allow distribute but it didnt.
The changing to enhanced mode is disruptive, you need a window maintenace to do this.
About the the roolback to the basic mode, it's easy if you want the same full zone and active in all fabric. Taking into consideration you are not using specific enhanced mode features, only the zone distribution.
The unmanaged mode is also known as Network only switching, which is introduced in Brazos release. It adds the flexibility for customer to use only network automation for service appliance.
If a device is configured a...
Usually, we can access ESXi Shell by pressing Alt+F1 from ESXi DCUI (Direct Console User Interface).
But on HyperFlex system, it just shows black window.
This is expected behavior because HyperFlex redirects ESXi Shell output to SoL...
Configuring an Export Policy Using the GUI
This procedure explains how to configure an Export policy using the APIC GUI. Follow these steps to trigger a backup of your data:
On the menu bar, choose Admi...