Thans for your reply. We have currently upgraded to 4.2.1.N2.1a.bin and has had no effect. We did upgrade further to Version 5 and all of our ports would not come up, so possibly the firmware on other CNA's cannot support the latest release.
We have also discoverd this which may be the cause?
We didn't qualify Brocade CNA on the Cisco Nexus 5000 series but as usual we could be pursuing this with following the standards on both vendor equipments, indeed the link you pointed out might be the issue.
Topology & Design:
Two ACI fabrics
Stretching VLANs using OTV
Both fabrics are advertising BD subnets into same routing domain
Some BDs(or say VLANs) are stretched, but some are not.
Endpoints can move betwee...
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
Topology &Design:Traffic flow within same fabric:Endpoint moves to Fabric-2Bounce Entry Times OutTraffic Black-holedSummarySolutionAppendix:
In the Previous articles of ACI Automation, we are using Postman/Newman a...