I have a Nexus 5548UP running 5.0(3)N2(1) and I want to enable the fport-channel-trunk command but I cannot enable this feature. When I issue a show feature I see it as a disabled feature but I cannot turn this on. I want to enable this so I can set up an F-Port Channel to a Fabric Interconnect 6120 (UCS).
I have enabled the following features
system default switchport trunk mode off feature telnet cfs ipv4 distribute cfs eth distribute feature lacp feature vpc feature lldp
Your N5k is configured to be in NPV mode and hence fport-channel-trunk is not a feature you can configure. However, the NP ports on the NPV switch can be bound into a channel/trunk to a NPIV/core switch which has
Topology & Design:
Two ACI fabrics
Stretching VLANs using OTV
Both fabrics are advertising BD subnets into same routing domain
Some BDs(or say VLANs) are stretched, but some are not.
Endpoints can move betwee...
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
Topology &Design:Traffic flow within same fabric:Endpoint moves to Fabric-2Bounce Entry Times OutTraffic Black-holedSummarySolutionAppendix:
In the Previous articles of ACI Automation, we are using Postman/Newman a...