Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

port channelling on two MDS9513's

Hi, I have two MDS9513's running SANOS 3.3. I have four ISL's between the switches but when i try and set up port channelling i get the message 'no ISL's available between MDS switches'. As yet the network is not live in our new data centre so i was wondering if SNMP is used at some point when setting up port channelling to identify switch type??? Enterprise license is installed on both switches.

1 REPLY
Bronze

Re: port channelling on two MDS9513's

A couple of questions:

- What sort of line cards are you using?

- What VSAN's have you got configured?

- What zoning policy do you have and have you got any active zonesets on either switch?

- Have you setup switch priorities?

It is probably a defect identified as CSCsg27664.

185
Views
0
Helpful
1
Replies