We have one site configured for services. All the servers are using SAN for storage. We need create a backup site with same hardware 30kms far. The SAN hardware at both locations needs to communicate. We are using Cisco SAN switches. Both locations can only be connected via E1 links.
How two SANs would be connected? We cannot have direct fibre link between SAN switches.
You may consider FCIP(Fibre Channel over IP Protocol). It is a tunneling protocol that connects geographically distributed Fibre ChannelSAN islands transparently over IP LANs, metropolitan area networks (MANs), and WANs.
You can find the further details on the following URL :
I suppose before you order your Cisco MDS switches you have contacted with local Cisco engineers.Depending on the modules that you have ordered , you can use your existing IP network to carry your FC traffic via using FCIP.
The unmanaged mode is also known as Network only switching, which is introduced in Brazos release. It adds the flexibility for customer to use only network automation for service appliance.
If a device is configured a...
Usually, we can access ESXi Shell by pressing Alt+F1 from ESXi DCUI (Direct Console User Interface).
But on HyperFlex system, it just shows black window.
This is expected behavior because HyperFlex redirects ESXi Shell output to SoL...
Configuring an Export Policy Using the GUI
This procedure explains how to configure an Export policy using the APIC GUI. Follow these steps to trigger a backup of your data:
On the menu bar, choose Admi...