I have connected brocade 300 to cisco MDS 9222i via 4 Gig FC interface. By connection diagram is as follows brocade 300 -> cisco MDS 9222i -> cisco MDS 9222i -> brocade 300. Two cisco MDS is connected to each other through 1 Gig Ethernet, FCIP tunnel is also being created using this 1 Gig Ethernet interface. Storage box is connected to the brocade switches at both ends. I want to test the remote volume mirroring between both storage boxes, for this I need to see both brocade switches under single fabric so as to zone their interface under single zone. Anybody can help me in this with cisco end & brocade end configuration?
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...