Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SN5428 Error Message

Do you know where can I find Error message references for SN5428?

When I telnet to the box, I have an error message:

[SN5428-1]$ Aug 14 08:56:16: %FC-fci1-5-QFPDBSLP: portDataBaseSync: Failed to login to portId=0x10200!

Has anyone seen this?

Thanks.

1 REPLY
New Member

Re: SN5428 Error Message

we are working on a message guide but is not yet available. This message is telling you that attached device on port 2 at domain 1 is not responding to a port login attempt. Is this device an initiator or target device? Many Initiator(host) HBA's reject a plogi attempt from other devices on the SAN. The SN5428 tries to plogi to all devices that have registered with the nameserver to determine if it is a target device, if it is a host device the SN5428 would determine it via a plogi/prli and then end the attempt to probe it, but because it does not respond to the PLOGI/PRLI you get the message. There may be a firmware upgrade for the Host HBA to have it correctly respond to the SN5428 login, if not it is still nothing more then a informational message. Changing the log level on the SN5428 can stop the message from coming to your screen if you wish.

150
Views
0
Helpful
1
Replies