Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SNMP TRAPS

Hi

I want to config snmp traps from my new mds9513 to SCOM

i configured the destination in Device Manager , and when i try to test it , we pool out one FC Port and got the Link Down Message

And when i Try to reset one Module i want to get an snmp trap and call home mail , but it's not working.

1. how do i have to setup this environment?

2. how can i get TRAP with Port Description insted of Link Failure %port....

Thanks

Ronen

2 REPLIES
New Member

Re: SNMP TRAPS

Hello Ronen,

Are you resetting the module gracefully (ie using CLI to reset) ?

Call home will not be generated in case you reload the module using CLI. Instead try re-seating the module physically.

Thanks,

Prateek

New Member

Re: SNMP TRAPS

Hi

Thanks for answering my question , when i  took  the module  out physically

it sent the trap/callhome .

how can i get callhome message with port discription insted of %port....when link goes up/down ?

Thanks ,

Ronen

488
Views
0
Helpful
2
Replies