Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SNMP v3 switch access only ?

Can I turn off SNMPv2 and have SNMPv3 and telnet/ssh access only

1 REPLY
Cisco Employee

Re: SNMP v3 switch access only ?

By default, I believe that there are no RW or RO communities enabled, so SNMP version 2 connections should be disabled by default. Not sure if you can disable the SNMP V2 protocol per se, but you can make it make unusable.

Hope this helps,

Mike

154
Views
5
Helpful
1
Replies