I'm trying to connect an UCS to a SAN based on McData SAN switches. I configured the WWN pools and the vHBAs. The SAN Admin told me, NPV is on the port activated and NPIV is supported.
On the swicthes, my WWPNs are visible and the SAN Admin configured the zoning and the presentation already. If I rescan the the SAN on my ESX, I can't see any path or presentated LUNs at all. LIP reset with no success.
in the past, I had access to the whole environment and there was no special configuration to get this working. At this time I was working with Brocade/HP SAN switches. Today I'm only responsible for the UCS an the vSphere environment and the other admins have no experience with UCS.
Any tips or hints will be very helpfull tu get this working. Do I have to make any special configurations? Does anyone have experience with UCS and McData SAN and can share the needed configurations with me?
Topology & Design:
Two ACI fabrics
Stretching VLANs using OTV
Both fabrics are advertising BD subnets into same routing domain
Some BDs(or say VLANs) are stretched, but some are not.
Endpoints can move betwee...
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
Topology &Design:Traffic flow within same fabric:Endpoint moves to Fabric-2Bounce Entry Times OutTraffic Black-holedSummarySolutionAppendix:
In the Previous articles of ACI Automation, we are using Postman/Newman a...