Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

use one IPS port to create tunnel to two remote MDS switches?

is it possible to use one gigabit port on MDS IPS 14+2 linecard to create FCIP tunnels between two other remote MDS switches?

each tunnel will  allow a different VSAN. this is kindda crude but gotta do it, if it can be done

Everyone's tags (3)
1 REPLY
New Member

Re: use one IPS port to create tunnel to two remote MDS switches

yes it can be done, make 1 FCIP profile defining the Ip address of the GE interface.  Then create 2 different FCIP interfaces ( tunnels )  each one will use the same profile, but have different peers.

552
Views
0
Helpful
1
Replies