01-21-2013 01:33 AM
Completely new to the Cisco switches, I'm struggling with some of the basics. Right now, I'm playing with the virtual fibre channel bits.
On a Nexus 5548UP version 5.1(3)N2(1)
conf t
int vfc 16
bind int eth 1/6
no shut
switch# show int vfc 16
vfc16 is trunking (Not all VSANs UP on the trunk)
Bound interface is Ethernet1/6
Hardware is Ethernet
Port WWN is 20:0f:54:7f:ee:e2:af:3f
From reading various guides and manuals, I expected "Hardware" to read "Virtual Fibre Channel". What am I missing here?
01-21-2013 07:46 PM
Allow only the vsan you need in this vfc
Example the active vsan 10
conf t
interface vfc16
switchport trunk allow vsan 10
end
01-23-2013 07:10 AM
Seems "Virtual Fibre Channel" is what you'll see in the Fabric Interconnect modules. At any rate, my configuration is working now.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: