11-28-2006 11:38 PM
Hi All,
I have noticed that when I turn on a new 9000 series switch, VSAN0001 is always down. I cant remember what I did the last time on the switches to get it active.
Normally, I just create a new VSAN and put the interfaces into the VSAN and during this procedure, somehow VSAN0001 became active. I just cant figure out how to make VSAN0001 active.
I just turned on two more switches and the same thing has happened again.
Any help would be appreciated.
Regards
Stephen
11-29-2006 06:52 AM
Enabling and FLOGI of any FC interface into VSAN 1 will change VSAN state to active
11-29-2006 09:19 AM
Here is one way.
config t
int fc1/1-xx
no shut
11-29-2006 10:06 AM
A vsan must have an actively attached device in one of the ports to come active. VLANs on the ethernet switches are the same way-they are down until something is connected in that vlan.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide