Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Zone Activation / Verification

Added some new zones today, but when I went to do a verification before the activation I got some extra steps....

CHESXIEA2_0_CHNCXLAB02_SPA1[WWN, WWN][Add, Add][Clariion_90602250-SPA1, Emulex_10:00:00:00:c9:91:3d:1a][SC-9222i-D02 fc1/6, SC-9222i-D02 fc1/2]
CHESXIEA2_0_CHNCXLAB02_SPA1[WWN+LUN, WWN+LUN][Remove, Remove][Emulex_10:00:00:00:c9:91:3d:1a, LUN 0x0, Clariion_90602250-SPA1, LUN 0x0][SC-9222i-D02 fc1/2, SC-9222i-D02 fc1/6]

Why would it be removing a zone and then re-adding it?  The only difference is the [WWN, WWN] and the [WWN+LUN, WWN+LUN] type and the LUN 0x0 being removed from the Members...

Thoughts?

3 REPLIES
New Member

Zone Activation / Verification

system displays all changes since last activation , before you activate the zone this time..

this includes your own changes and someone else's change if any since last activation..

e.g if someone else had made changes and not activated the zones, those should be displayed as well.

Silver

Zone Activation / Verification

if you add or remove zone members, it will display it like that.

@dynamoxxx
New Member

I have had the same

I have had the same experience on both fabrics.  I am continuing to check but so far no other admin seems to have made these changes.  Has anyone else seen this?  Our zones did not have LUN members.

498
Views
0
Helpful
3
Replies
CreatePlease to create content