Switches - Small Business

Hi, I'm trying to monitor memory utilization via SNMP on an SG200. I've downloaded the Small Business MIBs and used them to walk the SMMP tree on the switch, but I cannot find an OID for memory. I found the ones for CPU, and lots of other stuff, but ...

Hi Guys, Help needed, as I am encountered a problem and I would like discuss it with all experts here. As shown in the network diagram attached, some inforamtion about the network as below: 1. All the VLAN gateway is on Core Switch 2. The Core Switch...

HI, i am using above mention switches and i have created my network using 10.0.0.1 subnet 255.0.0.0 created ip pools and assigned to users as per pool on port 1, i have connected router and gave this router IP 10.0.2.1 and subnet 255.0.0.0 i am con...

Hello, I have two subnets in my office as below, 192.168.1.0/24 192.168.2.0/24 I need all the systems should communicate with each other. There are 4 switches of 48 Port and all are uplicked with each other. I just found that I can create VLAN routin...

HI, This is the running config for sg300 switcha86a4c#sh running-config config-file-headerswitcha86a4cv1.3.0.62 / R750_NIK_1_3_647_260CLI v1.0set system mode switch file SSD indicator encrypted@ssd-control-startssd configssd file passphrase control u...

I got my first 4948 switch.  I configured my management port Switch>show ip interface brief Interface                  IP-Address             OK?           Method          Status              ProtocolVlan1                       unassigned            ...

Hello! I have a SF220-48 smart switch which documented as support both port-based vlan and 802.1q vlan,  but while logging into the web admin page, I cannot find how to setup up the port-based vlan. Will someone help me on this or this device simpl...

i have an sg300 and and sg500, each running 1.4.0.88.  i want to setup raduis vlan assignment, and seem to be having some issues.  my radius server will reply with the attribute/value pairs to set the port to a vlan, but i think i am missing somethin...

Hello Experts, I am facing a problem we have 2 SF300 switches, they are connected by SFP module. we can ping from one end to another end  through PC. But my client have a software (type of Monitoring) on a PC its connected on SW1 and the SW2 have so...

Hi, I have a small network with just a few Cisco SB switches devided by a few VLANs. One of the swithes performs Inter-VLAN routing and also acts as a DHCP Relay. DHCP server is connected directly to the core switch. The problem is that it may take...

Hi, This year we deployed over a hundred Chromebooks in one area of our school for the Gr 7's (1:1 ratio).  Yesterday I found that the Meraki MR32's in that area (I have 3 of them dedicated for that area of the school) were laggy in terms of authenti...

Hi , I have a  SG 200-08 8-Port Gigabit Smart Switch switch. I connected it to dell sonic wall using a trunk port.Each time the power recycled the switch starts but the the tagged vlan 1 become untagged and the communication drops to sonic wall.I che...

Hi All, I have small business switches at roughly 140 sites.  Each of these sites are 192.168.XX.0/24. All switches are in the .230-.239 range. All access points are in the .100-.120 range. Firewalls are .1-.2. Basically I want to block management ac...