Switches - Small Business

Hi need someone to confirm my findings for this problem.So I've got a SG300-10 10-Port Gigabit Managed Switch (Firmware 1.3.0.62 ) in L3 Mode and QoS Mode in Advanced.So if I make MAC-Based ACL without entering a Ethertype and make IPv4-Based ACL or/...

good morning, nice to saludoarles, I write because I have a problem with a model SG300-28p switch, I explain:had run the company normally switch until one day we were completely without a net, the teams showed "Network cable unplugged" apparently the...

Why is it such a pain to change the IP?  I know now that you have the set the management vlan IP as static before doing anything else but once that's done and you then add more vlans and with their own static IPs why can't I change the management IP ...

Hi all,I have a switch that has an unusable web interface.  only have arrows / bullet's showing there is a menu item there, but no way to know what each menu item is... unable to apply a firmware update to it since I can't see the menus.I have the de...

Hello,I am currently in the process of configuring an SG500-28P Small Biz switch and am having difficulties obtaining a DHCP address for a Cisco ATA SPA 122 device that's plugged directly into the switch. The ATA uses CDP to communicate with the swit...

Hello guys.Im about to buy a new Gigabit switch, and i really like the SG300-10.My question is, is there a CLI on this box? or is it pure webmanagement?I will be using it for:ACLVLANsInter routingVTPTrunkingCan i do this from the CLI?I will be using ...

                   Hi I have a question link to the SG300-10 (SRW2008-K9) > in data sheet i have confirmation of a rackmount kit (even for desktop model) Could someone confirm's me the rack kit is long enough to match the need to install the small sw...

HelloI have a very simple question about CLI on SG-300. How to display trunk ports via cli? I have switch with 28 ports and I wanted to see what switchport mode is applied to every port - or simply we can just focus on trunk ports. On Cisco Catalysts...

FYI. There will be a new release of software this month.

Dear FriendsI wish you are fine .......... Kindly i have a question regarding Cisco Small Business 500 Series Switches ....... This series has reset button in the front panel ...... This button can be used to manually restart the switch or restore fa...

OK I'll explain my setupI've got a 3560 connected to an 1841 (router on a stick) but the trunk allows only VLANs 2-5. I didn't set it that way so I assume the previous owner did that for security reasons.  Well some time ago we got an SG200-26P and w...

HelloI have srw2024 switch and (3 access point , dsl line cable pluged in )and few users accessing network and internet thro that switch , when i try to make ACL Mac-based to deny requests from certian MAC address and bind it with the dsl port, rule ...

I have an SG300-52 in the field and the site recently picked up some VOIP phones. I currently have the followingExisting VLAN2 = Data networkCreated VLAN3 = Voice networkUnder voice VLAN properties I set the Voice VLAN ID=3 and enabled Auto Voice VLA...