Switches - Small Business

Hi AllI have 3 x SG500-52P switches stacked.Vlan 1 is data and Vlan 3 is voicePort to Vlan membership is 1UP and 3TPort security is disabledThe issue I have is that I can have either a phone or a PC plugged into a port but not both. If  I plug in bot...

Hi,I have a 302-08Mp attached to my network, it is plugged directly into a C3560G, however when i plug a phone into this switch i get a 'configuring ip' message up on the phone. The voice vlan is set identical to the 3560 but in the logs i get an err...

Hi!The switch SG500X-48 has 4 SFP+ ( 10G ) ports - XG1, XG2, XG3/S1, XG4/S2 - and two configuration modes - standalone and "native stacking". Can I use XG1 and XG2 SFP+ ports to connect servers when "Native stacking" mode is active ? Thanks,Leonardo...

Hello,New in a company that have 2 SG200-26, The system administrator left without giving any password.Is there a way to reset the password, I can't find something that applies on thos switches.The best would be to reset the password without reseting...

                   I changed the setting from static to dynamic and the switch froze up. all lights on the panel flashed, when they stopped the system light on the left side continued to flash. I tryied unplugging unit as well as depressing the reset...

Hello,i was able to configure (via SF200 web interface) a port mirroring from port FE17 to FE7.i have supressed this port mirroring.when i try to reconfigure a port mirroring from port FE17 to FE3. The SF200 web interface crash. the SF200 seems to re...

Helloi was able to configure (via SF200 web interface) a port mapping from port FE17 to FE7.i have supressed this port mapping.when i try to reconfigure a port mapping from port FE17 to FE3. The SF200 web interface crash. the SF200 seems to reboot.i ...

My setupCisco 2811 ISRLinksys SFE2000PCisco 7940 IP PhoneI have created 3 VLANs for this setupVLAN 2 - VoiceVLAN 3 - DataVLAN 10 - ManagementThe Cisco 2811 ISR connects to the SFE2000P via the FA0/0 port. Subinterface has been created on the cisco ro...

I have 5 VLAN's setup in the sge2010.  I have one port (uplink for the network) that I want everyone to see.  But have separate VLAN's for different departments as to keep them all separate.  Everytime i try and Untag that uplink port, i lose my unta...

Anyone have experience using Subnet Zero and the All-Ones Subnet on the SF300 series switches?We have a scenario which we are using an SF300 as a Gateway Device.  We have a /29 broken up into two /30 subnets.  We have two routers which need to be iso...

I am looking for some technical specs on the SF300 series which I can't seem to find in the 300 series data sheet:the maximum delay for traffic through the switchbuffer size for each switchportwhether or not the ports are suitable for shielded cable ...

We have a SRW2048 switch in out company network and suddenly it restarted it self. after logging in and check the flash logs there is the following error.%SOCK-F-MEM: SOCKP_tcp_open_call: Connection pool is out of memory  ***** FATAL ERROR *****  Rep...

I was positively surprised to find the optical transmit/receive values using the show fiber-ports optical-transceiver detailed command on a SG300-10. Now I'm wondering if there is also a SNMP-MIB to query these values?I've already tried the CISCO-ENT...