Resolved! DHCP Request
Hello all, Does anyone know if it is possible to request a specific DHCP adddress from the DHCP server on Cisco switches? (15.0.2 C3750V2) Gareth
Hello all, Does anyone know if it is possible to request a specific DHCP adddress from the DHCP server on Cisco switches? (15.0.2 C3750V2) Gareth
Trying to wrap my head around a recent problem. For the past five days, we have a single SG 500 switch that is powering off and performing a cold startup daily. It happens every 24 hours on the dot. I checked the logs and I don't see any errors - I w...
Current ConnectionPLANNED CONNECTION Hello Guru's I need your help about this network diagram, Currently we have two ISP provider, (ISP-1 ISP-2 as shown in the drawing ) and functioning separately. To optimize both ISP I want to make it redundan...
Got an issue where I am noticing that about 20% of the APs that are connected to this 4500 series switch are auto negotiating at 100 Mbps. I have checked many of the specific switchports to see if there is a hard coded speed, which there is not....
The sup2t in the 6807-xl supports up to 220 Gbps per slot. What does per-slot bandwidth mean?
I'm trying to get our syslog messages from a 4500 switch sent to our syslog server. I duplicated the same config that I was using from a differnet switch that's a 2960. However, the 2960 is sending info to the syslog server but the 4500 isn't. ...
Hi, I am a new in Network Technologies and I'm still learning and I would be pleased to communicate with intelligent people. Setting QoS on Catalyst 6506 I ran into the problem: after attaching a policy-map, which catches the necessary packets (ACL ...
Hello, Could someone, explain me what is difference between some redundancy protocols for example HSRP on router and Active/Standby failover on Cisco ASA ? What is difference between this two options (in functionality)? And why is Cisco ASA failove...
Hello guys, I am begginer in Packet Tracer, I have a problem with overlapping on router interfaces, and i don't know why it happens, what they mean or how to prevent them. The point of this topology is to can ping all devices from any of them...
We are planning to upgrade Cisco Nexus 5596UP switches which has FEX and in vpc. I haven't upgraded such an old version switch. Can someone please help with the upgrade paths and its steps. Currently running version n5000-uk9.5.2.1.N1.1.bin Target ve...
I have a cisco and Hp switch on Test Lab, The Cisco Switch is configured withmultiple vlans, IP dhcp server, default gateway (my router). The HP is connected to one of the ports on cisco swith, i set the default gateway on the HPas the Cisco IP. On...
Hi all, We are required to use ethernet links between Device-1 and Cisco 3650 switches in trunk mode.(You may see given figure below.) We are able to run trunk in device-1 without using any network protocol-based software so we have decided on usin...
Hello Cisco Team, I would like to know what are the pros and cons of Service Manager Mode and Service Policy Mode I understand the high level definitions of these from below link - https://www.cisco.com/c/en/us/solutions/collateral/data-center-virt...
CPU utilization for five seconds: 90%/11%; one minute: 84%; five minutes: 83% PID Runtime(ms) Invoked uSecs 5Sec 1Min 5Min TTY Process 1 34 78 435 0.00% 0.00% 0.00% 0 Chunk Manager 2 80024 504243 158 0.00% 0.00% 0.00% 0 Load Meter 3 152 912 166 0.00%...
Hello I will be trying to migrate from a Cisco ASA 5520 ver 9.1 to a Meraki MX100. Is there any templates that are available? Mostly looking for guidance on what an "Object-group" or an "Object-network" would translate to in the Meraki word. Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
04-24-2024 02:27 PM | ||
04-19-2024 05:58 AM | ||
04-17-2024 03:50 AM | ||
04-15-2024 06:06 PM | ||
04-12-2024 05:48 AM |
User | Count |
---|---|
11 | |
11 | |
10 | |
9 | |
6 |