Switching

  I have core switch 3560 and 3550 G series switch, can i run intervlan on this switch? I want to design network like.  ISP<------------ Core switch /3550./3560<-------Layer 2 switch<-------Client PC                For example     IP:1.1.1.1 Please s...

Hello, I am trying to prepare myself for a new project in which I have no prior experience with.  I am hoping someone could provide me learning material resources "reading, videos, advice, etc" for setting up a LAN that splits data and voice into a s...

Hi AllI have two switches (2960S's) both with IP Phones on VLAN100We need to monitor voice traffic via a monitor port on SW1 of all VLAN100 traffic on both switches.The following is what we have configured, but we cannot see VLAN100 traffic on SW1SW2...

I'm using a stack of (4) 3850's and would like to validate how many AP's I can connect.  I'm reading in Cisco Live presentations that a 3850 stack will only support 50 AP's.  I'm wondering if this limitation only applies to converged access or if it ...

I'm practicing a configuration in packet tracer that I will recreate on a real 2960 switch. I'm trying to configure an interface on a 2960 switch as a trunk port that will be connected to a Cisco aironet 700 access point. I want the 2960 interface to...

4 x 1G network module in 3650; do these swithports support 100Mbps links? I mean, could I plug a FastEthernet SFP on this ports?

Hi all,we will implement the following scenario:Hub connected to providers' MetroEthernet Switch (site A) (ME-A)Switch connected to providers' MetroEthernet Switch (site B) - servers on switch assigned to vlan X.QinQ should be used by the provider, s...

Hi guys . I  had an issue to connect two routers C892FSP-K9 gigabit #8  and CISCO891W-AGN-A-K9  fastethernet port #8  and ahd this :Jun 24 18:38:25.115 UTC: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet8, changed state to upJun 24 18:3...

Hi, We have in a branch office two 4Mo SDSL Line (MPLS).We put these lines in a port aggregation with load balancing in order to provide a better service. The two lines are up. We experienced these troubles :One PC looses one ping on three. Web appli...

Hi all, Is it possible to log violations of a mac access-list in cisco3850? That means PCs with mac addresses not belonging in my mac access-list when connected and attempt traffic in my switch will be logged for violations. TIA!

Hi,Tried to upgrade C2960-24PC-S to c2960-lanbasek9-mz.150-2.SE8.bin.When rebooting I get this error situation Error: ***Unsupported platforms***Error: hardware not supported by firmware.Try loading newer software instead.System resettilng...And so i...

Dear, I have confused that how to route inter-vlan traffic forward  to internet?  ISP cable connect to port 48. and live ip for example 1.1.1.1 Can you guide me ? Thanks.Junaid

Hello everyone,  so I have a question regarding a scheme I'm doing on Cisco Packet Tracer. Here is the preview since it's better than describing it with words: So i have all the vlans configured in the switches and everything is working inside the sa...