Switching

For an exercise we were given this scenario: The campus has a flagship building which has three floors and is dedicated for the use of computing degree programmes. The ground floor contains a café area and a large lecture theatre; it also has a recep...

Objective is to connect the site A and B with no single point of failure.Each site has:2 Ethernet switches which are connected to each other.2 routers router configured with HSRP. One router is connected to one Ethernet switch.Point to point Ethernet...

Hi All; I need to connect 10 G up-link from Nexus 5000 switch to Cisco 2960s switch, I have SFP-10G-SR SFPs but I need to know which fiber cables type I should use. Thanks in AdvanceAlaa 

Hi Everyone,I wanted to query the support community to see if folks are encountering issues in deploying the 6880-X in VSS mode.  We first looked at this soluition when it was running 15.1(2) SY2 as the recommened GA code.  We ran into several issues...

I've got a Cisco IE2000 industrial switch and do not know a whole lot about them. I connect this one to 24V. and it goes through the boot sequence (I can go into the console and see the IOS finish and come to a user prompt). After the boot sequence f...

Hi All, I'm designing an office LAN that has 4 floors and a comms room. I require 200 x 1Gbps PoE ports per floor with 10Gbps fibre connections back to the core located in the comms room.I'm thinking of using Cisco 2960X 48 port stack switches with 1...

Hello All, Im trying to use route-map using next hop. For some reason I am not getting any matching packets. SDM is setup for desktop routing. I am not getting any matches on my route-map nor my ACL.Code is 12.2(55)SE5 Configinterface Vlan11 descript...

Hello experts,Need your opinion. Our customer would like to expand their network with minimal impact on their daily operation. Recently, they are in the midst of acquiring 4 office floors in the same building and they would like to extend their exist...

Hello all you Network Gurus! I have an issue with the Cisco SG300 switch. In the logs of these switches(I have several of them on my network), I'm seeing the same messages: 10-Oct-2013 18:41:07 :%IPADTBL-N-IPDUPLICATE: Duplicate IP address 10.1.1.77 ...

Hello all,we're noticing the presence of Giants packets on the VSL Link on two 6509E with SUP2T (basically registered on the port used as VSL control link of the Active Switch Port-Channel).All other stats and errors are equal to zero but the number ...