Switching

Hi All,I was trying to route one of the vlan internet traffic to Head office ASA, this vlan is inside VRF Network. Head office is connected through ISP VPN cloud. still the traffic is going through local ASA. Please advise.interface Vlan100 descripti...

We want to route a DSL connection from one switchport (connected with a DSL Router) of a Cisco Catalyst 3650 in the bureau space to one switchport (connected with a end-device) of a Cisco Nexus environment (5548/2248) in the technical room. The dsl c...

Hi All,If I were to stack a 3750X-48T-E with a 3750g-24ts the formere with an IPservices image and the latter an IPbase image. Would there be a problem ?This switch will be used as a layer 2 only and the 3750G does not have any L3 license?Thanks in a...

hi all,saw this POST on a WS-C3560C-8PC-S switch.is this normal? i though status should all be passed.FIPS: Flash Key Check : BeginFIPS: Flash Key Check : End, Not Found, FIPS Mode Not EnabledPOST: CPU MIC register Tests : BeginPOST: CPU MIC register...

Hello there.How can we classify the IPv4 multicast range ( 224.0.0.0 - 239.255.255.255 ) in terms of Public or Private addresses ? regards.        

hallo , i have a question if my configuration for dual HSRP is correct, and if the HSRP failover works with natthank youROUTER 1========..track 10 interface GigabitEthernet0/1 line-protocoltrack 20 interface GigabitEthernet0/0 line-protocol!interface...

Hi, Is there any tool that can generate configuration for Cisco 4500 and 3850 IOSs when I will put all the IP, TACACS+, QoS info etc.?  Please let me know how to obtain it?

Hello,We have an ASR and its the only one at DC3. The overlay state is up but nothing is being forwarded. All other adjacencies out side of this site can be seen. Any ideas what the problem might be?ET-ASR1001-01#show otv site Site Adjacency Informat...

Hi All,I have a client that uses vlans that already exist on our network (vlan 1,2,3,99,100,200,250...) nethier of us are in a position to change the numbering at this stage.3750 stacks are on the client side and on my sidewhat is the best way to con...

Hi all, Is 802.11ac standard is approved or still in draft version. I am not able to understand the timelineshttp://grouper.ieee.org/groups/802/11/Reports/802.11_Timelines.htm

Hi,We have two 6509-E with VS-S720-10-3C but not in a virtualize environment.One of the core suddenly goes offline and couldnt able to boot from rommon.( this is the input i got from the resident engineer as the site is in remote)I might be traveling...

I am looking for help on what the QOS configuration should look like for a 6500 that sits in the core. I know there are many resources for me to read (and I intend to read them), but I'm in a huge crunch to get a friends connection up ASAP. All help ...