Switching

Hi I'd like to confirm that the behaviour of my radius configuration is what I'm expecting based on my configuration.What I expect is that I use my AD account information to authenticate into a switch. If the radius servers are unavailable then I can...

Hi!I collected structure switch in Cisco Dynamic Configuration Tool. After clicking "Check Configuration" appeared the following error:  "When both Primary and Redundant SUP7 Supervisors are ordered with  Memory, then the memory ordered must be equal...

We have purchased a number of 2911 routers.We got Base & security license as we wanted to enable encryption. However we probably wont use the security.We are replacing 2811 routers.Unfortunately the 2811 routers have FXS ports with 2 - 4 POTS handset...

Hi guys,,I got a situation,,I am logged in to one of our switches via telnet via putty.we have a tacacs+ configuration and switch is lcoated at the remote site.Due to some misconfiguration we ended up removing the aaa new-model command.and now we are...

I am getting the following on my switch.Apr 17 05:45:51.254: %SW_MATM-4-MACFLAP_NOTIF: Host 0008.9bd2.515c in vlan 1 is flapping between port Gi1/0/9 and port Gi1/0/7Apr 17 05:46:25.102: %SW_MATM-4-MACFLAP_NOTIF: Host 0008.9bd2.515c in vlan 1 is flap...

hi everyone,i have a  cisco WS-C2960S-24TS-S switcher,now i want to configer DAI on it.I have updated the IOS of the 2960S to the latest:Cisco IOS Software, C2960S Software (C2960S-UNIVERSALK9-M), Version 15.0(2)SE2, RELEASE SOFTWARE (fc1)I found i c...

Hi all,We currently have a 3750 switch in our office configured with DHCP. This 3750 switch is located in the central office comms room located at ground floor. We also have Cisco 2960 switch located in each floor of the building. Below is the descri...

What does this error message mean? How to fix the problem? The set up is this: router is configured as DHCP server with a single client manually bound. The client receives its IP address and default-router address, as configured, as expected. The cli...

Hi, Suddenly my 2960 D series switch went offline and i founf the switch was not powering. I can't figure out the issue. Please help.Thanks,

I have an inquiry about a configuration I deploy in a C2960 switch. I have configured a ether channel with 8 ports, the load balanced method is source mac address. The bundling protocol is LACP.I have found the ether channel is not balanced as I expe...