I'm trying to extend the range of an E3000 with a WAP4410N. The E3000 was super easy to install, and the WAP4410N isn't. Does anyone have a good way to set one up?
Hi Friends,I enable the VTP Trap by using following command.!snmp-server enable traps vtp! But This error is occur I thing I wrong some where pls suggest how resolve the issue.My purpose by enable the trap generation I have to maintain the log for VT...
Hi All,Am newbie with FO communication with Cisco switches.Am using Catalyst WC-2960 switch with FO patch panel to route fiber optic communication. It's working fine, but communication lost occurs randomly. If am trying to ping my devices on the othe...
Hi all,I'm having problems contacting a device after connecting it to our switch (3560).I've configured the device with an ip of 10.32.0.26/29 with 10.32.0.25 as the gateway. I've then configured vlan 9 with the gateway address. I can ping the gatewa...
I am using 3560-ts-s and updated with IP services image. i want to route two networks 10.0.1.1 and 10.0.2.1 through the 3560 using eigrp. I also need to configure HSRP on the same switch. the part of configuration is belowIP routing!interface FastEth...
Has anyone seen an issue where the N7K CMP port only works at a gig? I'm trying to connect a CMP port to a 3550 being used as a out of band mangement switch. I can't find a way to change the port speed on the CMP. It only seems to work if I use a ...
Hi AllOne quick question.. Does the subnet mask defined in a prefix list be the same as the entries on a BGP table or routing table ?for eg if i have 10 * /32 routes on a particular router (10 different loopbacks), can i have a single prefix list wit...
I need to allow BPDU traffic for a department, will this work?Switch1interface fast 4/1description "IT-Helpdesk Dept"switchportswitchport mode dot1q-tunnelswitchport access vlan 800speed 10duplex fullno cdp enableno snmp trap link-statusendinterface ...
in a vlan generally we go for the first ip as the gateway for ex172.16.0.0 - network, gateway will be 172.16.0.1 can we have 172.16.0.254 as the gatewaythe reason is we have a vlan 172.21.0.0 with 172.21.0.1 gateway we want to subnet it but one of th...
one basic doubtwhen i create a VLAN 172.16.30.0/24generally i do the routing in EIGRP as network 172.16.0.0 so can we use network 172.16.30.0 0.0.0.255 in eigrp routingkarthik
We are considering using VSS, with a second 6500 we are procuring. Originaly the intenet was to configure the second 6500 as a redundant fail over switch, but I am considering going with a VSS solution instead. The 6500's will make up the core...
Hello, I have a small issue about DHCP, I need two servers of DHCP.1 - Provide by Switch Cisco range 172.17.52.02 - Provide by Windows Server range 10.10.10.0 Everything works ok, but when I have a Computer using vlan 101 (at interface GigabitEther...
Hi,Last Sunday, i have the Cisco 6509 in version 8.6(4) that rebooted without reason. And i saw there is crashfile generated for that reboot. I tried to search for software or hardware failure but could not see anything.Can you help me please?I attac...
