Switching

Hi All,I'm relativly new to the world of cisco so my appologies in advance if my question is lame, or in the wrong place.Question is this.. About to purchase a PIX-515E with a limited license to serve as the primary Firewall/NAT device for an upcommi...

Having a really hard time here and hopefully someone on this forum can help me get this EtherChannel working. I have two Cisco 3560G 24 port switches. I am using ports 25-28, with SFP modules, between the switches as an EtherChannel. The problem is, ...

I have searched the site for references to DHCP option 85 and am unable to find any? Some time ago we have moved the dhcp segments from Novel servers to CISCO 2811 routers using the option 85 ip 10.10.x.x. to point to the servers.  We have recently m...

hello:I have 3 separate questions,.(1)(a)  Imagine I have a server with 2 NICs and I want to team them. If NIC 1  is connected to access switch 1 and NIC 2 to access switch 2, the only  NIC teaming methodology that can be used is one in which one NIC...

According to some Cisco 360 R&S lab documentation I'm reading the command 'srr-queue bandwidth shape 4 4 0 0' will result in queue's 1 and 2 getting 25% of the shaped bandwidth each.  I could understand this if the last two 0's were 4 but they're not...

I have a very simple problem (I hope)I have a Cisco 3750 with Vlan 1 (192.168.60.4/24) and Vlan 200 (10.150.112.21/24)I have a host (192.168.60.35) in port 10I have a host (10.150.112.8) in port 45Each host can ping its own default gateway and can pi...

I am currently testing some PVLAN configurations and so far almost everything matches what I am expecting to see.The most confusing part of the testing is that when I connect a sniffer and run ICMP packets back and forth I can not find the VLAN tag a...

Hi,I have the following NAT rate limit commands in my 2851 router config:ip nat translation max-entries all-host 1000 ip nat translation max-entries list 27 10000I would expect the router applies 10000 entries limit for the packets match ACL 27 and 1...

Hello,Can you please help me with subject?I tried to do it using SNMP, but it failed...I can set port UP or DOWN using a script (just set SNMP OID values), but I need to set a port speed (10/100/1000).Surely I know how to set port speed using tty )Th...

Hi,I would like to know that is there any command that we can use in the Cisco switch in order to check whether a switch port is either a Layer 2 or Layer 3 port?Thanks.