Switching

I have a customer who want his Dagobah and Swamp Revision revisions to match. The cat 4000s have the same ROM version, but different revisions. I don't know what to tell him what the Dagobah Revision and Swamp Revisions mean.

We're working to pinpoint the cause of a stack master re-election. Here's the scenario:Setting all ports on a 3750 48 port switch to vlan dynamic, using the int range command, 24 ports at a time.Enter configuration commands, one per line.  End with C...

hione 4507R switch having vtp domain with many vlans (vlan 20 vlan 30 , vlan 40 vlan 50 .....etc..) with ip interfaces and all other swithes 3500, 2600 series are connected by trunk link and vtp client with vlan access port and all system and server ...

We have a strange issue where every time we try to enable a trunk on our VSS switches, we lose our EIGRP adjacencies.  We have an 8-port 10GE blade in slot 9, and we are using ports 1/5/4, 2/5/4, 1/9/8 and 2/9/8 for our links between the 2 chassis.  ...

Hello Cisco Support Forums,Recently I setup a power calculation for a 6513, but the results are very different from what we see when we run 'show power'.------------------ show power ------------------ system power redundancy mode = redundant syste...

Hi All,Switch 1 (3560G) : Vlan 20, 30.50  --> Uplink --> Core SwitchSwitch 2(3560G) : Vlan 25, 30.50  --> Uplink --> Core SwitchI want to span the few ports on switch1 from Vla 30.Is it recomend to  span the Vla30 as source port on Switch1 (destinati...

Have this 3750G 48 port Gigabit switch in operation using multicast with minimal traffic now (320 M/bit). Would like to create 5 VLans each with approx 700 M/bit of multicast traffic. Question: Will this switch be capabable of this load? Is it OK for...

hi, i have a Cisco 6509 and after to introduce the command "hw-module module 6 reset" in order to perform a reset, this module turn to rommon mode.after that if I introduce de comand "boot" the module turn in HOT STANBY mode.I attach some captures.Re...

We currently have a single 6509 chassis with redundant Sup720 modules. We just purchased a second 6509, and will be moving the secondary Sup720 to this chassis.I would like to know the "best practices" for setting this up:1: Inter-switch links - conf...

Hi All,I have question regarding connecting two VLAN's on 7600.The schemat is like below:[7600] <-- TRUNK --> [SWITCH] |--PORT IN VLAN 1501--[PC1 IP 1.1.1.1 255.255.255.0]                              |                              |--PORT IN VLAN 15...

Hello,Checking the 3750x ordering guide, I would like to know what is the purpose of C3560X-48-L-S.Using the configuration tool I got the following:Product                       Description                                                 Quantity  Di...

Hi All,I have 2 4507 core switch , in this 1 core switch cpu process is high.