Switching

The question I have is related to VSS redundancy.Setup:2 6509 VE Chassis with SUP 720.We have 2 10 Gigabit links to each switch for VSS/VSL traffic.One connection is on the SUP itself and the other is on a WS-X6716-10G-3C module.We have connections o...

Hello All,I have a question about a simple multicast setup with a 3750 (IP Services) and a multicast capable camera.  I have 2 VLANs configured.Vlan 610.0.6.1/24Vlan 710.0.7.1/24The camera is connected to a port in VLAN 7 and is configured with the f...

Hello Experts,I was searching for a IOS for our C4506 switch SUP II+ engine, with following features. I had searched in the software advisory on cisco.com but no help.1. PBR with multiple tracking options2. IP SLA3. No EIGRP stub routing.Appreciate y...

Hello Everybody,I was looking for a IOS which can support IP SLA on our C4506 switch. Currently we have 12.2(25)EW installed and need one IOS of the same 'Basic L3' category which could support IP SLA.ThanksArabinda

Hi, firstly I am still very new to Cisco switches so please bear with me.....I have two servers here and have setup multicast Network Load Balancing which has worked fine.Server 1 - 192.168.1.12Server 2 - 192.168.1.11Virtual IP Adress - 192.168.1.4Th...

hi.we have old test equipment that has to be configurated using vt-420 terminal.we used to have cisco AS2511-rj device we use to connect those devices, so that ip-address,port 2001 did go to test device 1 and ip-address, port 2002 did go to test devi...

Could youpleas give me the correct upgrade  steps & commands for ASA 7.2(4) to 8.2(2)thanks

As shown in the attached diagram, I have a connectivity between two data centres.Switch A an B are in same data centre and C & D are in same data centre.currently two data centres are connected via a L2 trunk link and I need to have a another connect...

I'm looking for info about private vlan and vrf on 6500. Can these work together? May I put a private L3 interface into a VRF?Thanks.Regards.Andrea.

Hi,on my network a particular host is using more Bandwith. What the show command i can use to identify which host is that and what the bankwith its using.The network has the ASA connected to the internal router and the router is connected to the edg...

I have an end user reporting extremely slow file transfer times from a NAS device to a Unix server on the same subnet, in the same VLAN, and on the same switch. I want to know if the "valid frames, too small" counter as shown below is a reason for co...

hi i am getting a below error message in a 3560 switch%DUAL-5-NBRCHANGE: IP-EIGRP 1: Neighbor 172.31.1.2 (GigabitEthernet0/1) is down: retry limit exceeded%DUAL-5-NBRCHANGE: IP-EIGRP 1: Neighbor 172.31.1.2 (GigabitEthernet0/1) is up: new adjacency%DU...