Switching

Hello Experts,Currently I am facing issue in my HSRP as it shows Active for few interface on both Routers.RouterA -  2800 series - MPLS link- BGP protocolRouter B- 2600 series- ATM Link- Eigrp ProtocolAs per my knowledge I have configured all the set...

Dear sir,router----------point to point---router   '1                                     1   internet                           lani have central cisco router having ISP and its working fine now i connected one point to point connection using serial...

Hello,I am trying to trunk a 2960 (on g0/1 and g0/2) to a 6506 and have connected the switches with multimode (50 micron) fiber (LC one end, SC at the other). The 2960 has GLC-SX-MM SFPs and the 6506 has a 6516-GBIC card with 1000BaseSX GBICs.I don't...

Hi all,We are looking to implement a VoIP telephone system.I know the phones we are going to have use 5 watts each yet when I look at the switch port they are plugged into, it says it is giving out 15 watts. I think this has something to do with the ...

Hi,I got a Catalyst 3750 working with the IP features IOS.I tried to configure some MAC filters in a couple interfaces and they seem not to work properly...The scenario is the following. I got 4 busses (hubs) that are connected to a bridge. The bridg...

I have an applications that will be using roughly 16k-64k IP addresses directly connected to a switch, That is .1/24 will be assigned on the switch(or router)  and the full subnet will be used by hosts.These can be broken into groups of 32 class Cs p...

Dear All. We Are using Cisco 1841 router at location A and Location B. Both router is connect with RF Link In Bridge Mode using Fa0/1 on Both Router. Location A ---- Fa01 ---- Ip Address 192.168.1.1/24 Location B ---- Fa01 ---- IP Address 192.168.1....

my name is choong. i have been studying for ccna. i have a lab with 3 routers and 3 switches. the routers i have are 3640, 2 2610. the switches are 2900 xl series. i redo the ios on one of my 2610. i have 2 rom files when i did the ios how can i get ...

I asked a question about this last week and didn't get any replies, so I'm giving it another try.  I have a 2811 that I am using to forward multicast packets to multiple destination VLANs.  On one of these VLANs I am NATing the source IP addresses of...

We are going to move to VSS, and some of the blade servers we have don't support VBS, so I can run MEC to the switches. I would like to use switch ports in the BACKUP config.Router(config-if)# switchport backup interface fastethernet 4/1With changes...

Hello,Currently I have a network that is set-up with a simple star topology. 2 7500 routers that connect through about 90 T1 lines with cameras at the ends. On the end of one T1 line I have a router, an encoder, and a analog camera. The encoder suppo...