Here is the 3560 conf file:interface Vlan25 description Test ip address 192.168.25.1 255.255.255.0 ip helper-address 192.168.0.14...no ip forward-protocol udp tftpno ip forward-protocol udp tacacssw_core#sh ip interface vlan25 ... Vlan65 is up, lin...
When setting the boot parameters for the BOOTVAR, several options exist for the 6500 series in Native mode. I choose the source location, file name and other options. Somewhere/somehow the BOOTVAR (show bootvar) adds a ,1; to the end of each IOS file...
Hello,I have a Cisco 877 that when ever it is switched on it will default to rommon mode, if I type reset it will boot up the IOS and startup/running config.Show version displays the congiguration register as 0x2102The ISO is c870-advsecurityk9-mz.12...
In order to use a boot statement does the config register have to be 0x2102 . If the register is currently 0x2101 does it just look for the 1st image in bootflash and load that regardless if a boot statement is specified or not ?
I Have catalyst 2960-24TC-L , when i read the datasheet see this word :! RU fixed-confuration, <strong>multilayer switch</strong> main ---.> can be routing betwwn vlan ??
I will be deploying 2 4900M switches uplinked together in a network for intensive video applications. My question is how to constrain multicast traffic with these 2 switches. Since the network is flat there is no real interfaces required except for...
Hi All,i have a switch 4507 which's connected with 20 floor switch 3560. i have about 600 user.i want to know what's the best solution for implementing port_security with 600 @mac.i configure them on the federator switch or in the floor switchs.thank...
I am pretty confident of how to do the subnetting of any paticular class but what i am doubtful about is the concept, when you chose certain number of bits from the host portion in order to be used as subnet bits. Do we use the formula [b]2 to the po...
Hi allwith voice vlan config on my switch, what does the command do, does it tag packets with with whatever vlan comes after the command, and then reads untaged packets for the normal access vlan?so we could use a trunk with the native vlan also for ...
We have cat3560 switches. I have setup switches for threshold alerts in LMS 3.1, but some switches show more variables than others. How can I check variables on a switch so that it can be compared with other switches?Thanks,
Is there any tool or software through which i can manage vlan and ip address for my network. there are more than 500 vlans, which i am maintaining excel sheet as of now. pls let me know if there is any other way to maintain the same.
