Switching

Hello,I have some problem, i can't disable 2 command in router:ip auth-proxy max-nodata-conns 3ip admission max-nodata-conns 3Because of this i can't activate some another command, for example: resource policyor,ip subnet-zeroPlease, can you help me ...

Is it possible to route based on whether a specific subnet is part of an ACL and how do I go about configuring, eg a static route exits 1.10.10.0 255.255.255.0 10.10.10.1 but only if the packet coming in is a member of a particular ACL.Any help would...

HiI am moving a company's network ip address range from 192.168.1.x/22 to 192.168.1.x/24 (Other VLANS will also be created)My question is: in the VLAN where now all users and servers exists, i want to start changing manually the Subnet mask of the se...

Can I attached the switches as shown in the attachment, i.e. regular switch ports (gigabit ports) on the Catalyst 2960 to one of the uplinks on each of the three Catalyst Express 500 switches?

Hello experts,Since there is no way to change the topic i repost this conversation here.I have this problem:3 switches - 1 - 4503 and 2 - 3750They run in a cluster.There is one 802.1Q trunk from each 3750 to the 4503.On the 4503 i create 2 VLANs with...

Hi, I have a network of 3 switches given in the diagram. I can ping any Ip from 2960_1 but I cannot ping even gateway from 2960_2. Can you tell me the problem. But can pingable any IPS from the Laptop connected that switch

Hi, I have these case:I'm attaching a diagram where appear a simple interconetion:I have a host with a private IP address, which is being routed to manage purpose. I want to configure an overload nat, just because i need the bluecoat device contact a...

Hello All,I am faced with a situation here. I a working on an concourse extension network. A proposed solution was to have two paths to achieve redundancy. The traffic will carry data for CCTV, PAS, BHS, etc. My question- Instead of the expenive comb...

When requesting "show interfaces Gi3/1" on my MLS i get the following output:GigabitEthernet3/1 is up, line protocol is up (connected) Hardware is C6k 1000Mb 802.3, address is 000f.f89b.4c0a (bia 000f.f89b.4c0a) Internet address is 192.168.220.89...

I have a 6509 running 12.2(18)SXE4 with a 10gig card in slot 9. When I do a show module, or a show run, everything looks fine. i.e. the ports on the 10gig card show in the config as 9/1-9/4. However, when I enter config mode, and try to access Interf...

Can someone confirm how many Twingig convertor modules by default are shipped with the Sup 6-E ?Are -by default- two Twingigs shipped (one for each 10GE port), or just one Twingig for only one 10GE ?(can't find that in documention)tkx,Geert

Anyone know when LLDP-MED was implemented (ios version) looking for 3550-24pwr and 6509s specifically, not finding much on it in searches

Hi all, can anyone tell me what the broadcast command does when you configure frame relay maps ?

Is there a way to configure a port on a 2950 L2 switch to be assigned dynamically on a VLAN, depending on who is connecting his laptop on that port ? (VLAN informations are sent through a trunk port). I have an L3 switch on my backbone to do the rout...