Switching

Dear All,Can you please help me to solve a problem related to WCCP?. i have two cisco 6509 switches, and i have VLAN 100 configured as a HSRP group, this VLAN comes from external network and the users use it (VIP 192.168.100.1) to access the internal...

For the CPU statistics in Cat6500, what would a good percentage/size value for the entry in subject. And how can I view the CPU statistics.

Im trying to setup a voip lab. I got a 7940 connected to a 2950. The port goes err-disable when the 7940 is powered off.%PM-4-ERR_DISABLE: loopback error detected on Fa0/6, putting Fa0/6 in err-disable stateAnyone knows why?

Hi, We have to configure ip flow-export commands(Mentioned below) on 1721 platform. current DRAM/Flash is 32/16 Please let me know- 1- is these commands are supported on 1721 platform? 2- if it is, please suggest suitable IOS with feature set. 3- do ...

If the 'ntp server' is configured on Cat6500, would it automatically apply to all the service modules loaded in the chassis or would the modules need independent configuration. I have checked that FWSM takes it from the Cat6500 switch.

guys i have four swicthes all are connected to each other....MST is running and i have two instances.....swicth A and is root for instance 1 and swicth B is instance for instance 2......now th eport between A and B is 10 and 12......i want that odd v...

Hey I'm getting into switch and routers stuff, and I wonder if there is some way to know how many routers, switches or hubs are between 2 pc (server - workstation) in a given LAN, including hardware information like mac -addres 'casue I'm trying to f...

In case of two perimeter ASA's for e.g. with CSC-SSM and then AIP-SSM, I would like to connect the management interfaces to the management vlan. Should I create separate management vlan for ASA1 and ASA2. Because if they are in the same vlan, then an...

On the wireless side you have AssureWave certified IOS but on the R&S side of the house where is a good place to find a certified/approved IOS. Does cert.gov or another government site recommend software?

I used the following entry on Cat6500show memory debug leaksand it took up 100% of the CPU. Can 'show' commands eat up so much of CPU. I believe they are only display commands.

I am using VLAN2 for management and VLAN3 and above for data. Do I still need to assign an IP address to VLAN1?Many thanks for you helpMark

On a 2960...what is the command to show if portfast is enable on the ports?