Switching

DHCP Server Port-Based Address Allocation is a feature that allows for preassignment of an IP address to a port. One limitation of the feature is that only one IP address can be assigned per port. http://www.cisco.com/en/US/docs/switches/metro/cataly...

We have several 4500s that run SSO and ISSU. Because of some legacy equipment connected to the supervisor card, we want the top blade to become active so long as it's not in error. Each time we reload, the b/u supervisor is promoted to primary. Is...

We have a gig 3750 and want to limit the speed in and out of one of it's ports to 768 to simulate a fractional T1.I'm having trouble finding the best way to do this. Thanks,Andy

I just wanted to know if anyone knew why "File Management" would be grayed out in SDM. Thank you.

Is there anyone aware of any issues in using all 10 slots in Cisco 4510 switch. I remember there were some backplan issues in WS-C4510R when you use all slots including slot 10.

All,I know I have printers that are broadcasting ipx packets. I've turned off the ones that I could, but now I have a new problem. I'm seeing several macs from a wireshark capture that is broadcasting, but in my 3750, I see those mac addresses being ...

i have a cisco 4507 Switch connected to ISA server with a DHCP with different DHCP scoop but when i try to connect a pc with different VLAN than the native one it can't an IP address from the DHCP server so what is the command which allow the DHCP tr...

We have user report one-way audio issue. Trace the destination address 10.10.169.136 from the source switch a couple of times. We recieved total different result. Please see the below:IDFA#trace 10.10.169.136 1 10.210.20.3 0 msec 4 msec 0 msec 2...

Hello, could anyone help, we have a cat 6500 with a SFM, recently the SFM display started showing Power Unit Fan Alarms, we replaced the power unit, the messages still show on the display at the front off the SFM, does anyone know if there is anyway ...

I have defined the ca key pair and allowed the source network on 'ssh' command with corresponding interface. The aaa authentication for ssh is LOCAL.I can successfully ssh into the inside interface but not management. Is anything else required to ssh...

I have a 3560 and I created two Vlans on it. I created vlan 100 and vlan 110.This switch is running in layer3 so it will route. I started the DHCP server because we need to enable dhcp.I created two pools and I called them vlan100 and vlan110vlan100 ...

I want to replace a BT Internet modem with a cisco 2811 ADSL ISR.Please what information do I need to get from BT to successfully configure the ADSL router.Regards

HiI want to see where a pix firewall will send packets destined for ip 10.51.3.2, how can I do this on a pix firewall? I tried "show ip route" but it doesn't work.ThanksDan