Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 

Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

Start a conversation

Resolved! Stack 3750

hello, i have a problem , i have a stack of switchs 3750-24ts,3750-48ts and i want to add and 3750G-48PS switch to the stack,but When i connect the sw 3750g-48ps to the stack of switchs working those switchs block their console port and do not permit...

sERVER REQUEST TIME OUT

hI i HAVE SERVER TO CONNECTED TO BLADE SWITCH, NOW I AM VERY FREQUENTLY GETTING REQUEST TIME OUT FROM THIS SERVER. I HAVE CHECKED LOGS IN THE SWITCH, I COULDNT ABLE TO FINE ANY LOGS TO THAT PARTICULAR PORT/VLAN WHERE THIS SERVER IS CONNECTED cOULD YO...

7600 PFC QoS - Policer question

Hi Sir,I have a Cisco 7609 running IOS version 12.2(33)SRB3 with dual SUP720-3BXL.Two devices are connected to ports Gi3/1 and Gi3/2. Both ports are in VLAN 901 and there's an SVI for VLAN 901. Module in slot 3 is WS-X6748-GE-TX.I'm trying to rate li...

Inconsistent Network operation

We have a Cisco Catalyst 500 Ethernet Switch connected to a Cisco 871 Ethernet Access Router.The network is basically 1 VLAN with approx. 10 Computer Hosts and 10 Commercial Printers.The Vlan host IP addresses are static local IP numbers. (10.40.6.X)...

dbdickson by • Level 1
  • 321 Views
  • 1 replies
  • 0 Helpful votes

Resolved! Speed/Duplex Question

if its determined that a LAN device is too far away from the switch, and its presently operating at 1000/full, is there any sense in changing the duplex setting from full to half?If the LAN device (printer) can support it, I can see changing the spee...

lamav by • Level 8
  • 364 Views
  • 5 replies
  • 0 Helpful votes

Resolved! Over flow errors on Trunk port

Hi all,We have 6509 CatOS switch which has port 3/4 and 4/4 as Trunk Ports.I did sh top util and found that trunk ports have over flow of 2977 and 18384sh top utilStart Time: Oct 23 2008 01:00:50End Time: Oct 23 2008 01:01:21PortType: ...

mahesh18 by • Level 6
  • 306 Views
  • 2 replies
  • 0 Helpful votes

SNMP source-interface?

Is there a way to lockdown SNMP traffic so that it only transmits on a "management" VLAN? Obviously I could use access-lists, but I don't want to roll that out to all my switches. Surely there has to be a way to limit this traffic to a VLAN, then I...

Syslog server?

What syslog server do you use? I've tried Kiwi and Solarwinds. I'm not crazy about Kiwi because of it logging to text files, and the Solarwinds version that we have is from the Engineer's toolset which doesn't allow you to select SQL databases. (It u...

Resolved! Help with 3825 and 3560 setup

Hi proz, I need help configuring my 3825 router and 3560 switch for voip setup.1)Basic configuration(as these are out of box).Any config docs or step by step guidance would be great.2)Enable dhcp on both the devices.3)Auto qos need to be enable...

No switchport vs. ip routing

On a L3 switch, does no switchport take the place of ip routing? If I have ip routing disabled, and go to interface g1/0/5 and run no switchport there, and assign an address, will it have the same effect? (route traffic, etc.)Thanks!--John

NAT outside Server to Inside IP address

I am trying to NAT a server (192.168.100.109) connected to an Outside interface (172.16.110.210) on a Cisco 2611XM. I am trying to NAT the server address to an address on the inside interface (192.168.25.1) so I can connect to the server via a t1 usi...

2940 and Wake On Lan

Is there a way to get Wake On Lan to work on end devices connected to a 2940 without 802.1x and port security?2940 runs a basic Layer 2 access switch configuration.

kris55s by • Level 1
  • 1360 Views
  • 5 replies
  • 0 Helpful votes
View All
Review Cisco Networking products for a $25 gift card